User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
82
Set password. For the second generation access controllers, set the personnel
password; for other devices, set the card password. The new password must consist
of 6 digits.
Configure card.
The card number can be read automatically or filled in manually. For automatically read,
select a card reader, and then place the card on the card reader. The card number is
read automatically after that.
1) Click to select Device or Card issuer as card reader.
2) Add card. The card number must be added if the non-second generation access
controller is used.
3) After adding, you can select the card as main card or duress card, or replace the
card with new one, or delete the card.
Configure fingerprint.
1) Click to select Device or Fingerprint Scanner as fingerprint collector.
2) Add fingerprint. Click Add Fingerprint and press finger on the scanner three times
continuously.