User's Manual

18
3.8.1.1 Period Config
You can configure 128 periods (weeks) whose number range is 0–127. You can set four periods
on each day of a period (week). Users can only unlock the door in the periods that you set.
3.8.1.2 Holiday Group
You can set group holidays, and then you can set plans for holiday groups. You can configure
128 groups whose number range is 0–127. You can add 16 holidays into a group. Configure the
start time and end time of a holiday group, and then users can only unlock the door in the
periods that you set.
You can enter names with 32 characters (including numbers, symbols, and letters). Tap to
save the holiday group name.
3.8.1.3 Holiday Plan
You can add holiday groups into holiday plans. You can use holiday plans to manage user
access permission in different holiday groups. Users can only unlock the door in the period that
you set.
3.8.1.4 NO Period
If a period is added to the NO period, then the door is normally open in that period.
The NO/NC period permissions are higher than permissions in other periods.
3.8.1.5 NC Period
If a period is added to the NC period, then the door is normally closed in that period. Users
cannot unlock the door in this period.
3.8.1.6 Remote Verification Period
If you configured the remote verification period, then when unlock doors during the period you
configured, remote verification is required. To unlock the door in this period, a door unlock
instruction sent by the management platform is needed.
You need to enable the Remote Verification Period.
 means enabled.
 means not enabled.