User's Manual

28
Name
Description
Anti-fake Threshold
This function prevents people from unlocking by human face images
or face models.
Temp Parameters
Set whether to enable the body temperature monitoring.
Temp Unit: Select a temperature unit.

Temp Rect: Set whether to display the temperature monitoring

box or not.
Temp Threshold (°C ): Set the temperature threshold. The

monitored body temperature will be judged as high temperature
if it is greater than or equal to the set value.
Temp Correction Value: This parameter is for testing. The

difference of the temperature monitoring environment might
cause the temperature deviation between the monitored
temperature and the actual temperature. You can select multiple
monitored samples for testing, and then correct the temperature
deviation by this parameter according to the comparison
between the monitored temperature and the actual temperature.
For example, if the monitored temperature is 0.5°C lower than
the actual temperature, the correction value is set to 0.5°C; if the
monitored temperature is 0.5°C higher than the actual
temperature, the correction value is set to -0.5°C.
Only the access controller with a temperature monitoring unit
supports this parameter.
Mask Parameters
No detect: Mask is not detected during face recognition.

Mask reminder: Mask is detected during face recognition. If the

person is detected without wearing a mask, the system will
prompt mask reminder and passage is allowed.
Mask intercept: Mask is detected during face recognition. If the

person is detected without wearing a mask, the system will
prompt mask reminder and passage is not allowed.
3.10.3 Image Mode
There are three options:
 Indoor: Select Indoor when the access controller is installed indoors;
 Outdoor: Select Outdoor when the access controller is installed outdoors;
 Other: Select Other when the access controller is installed at places with backlights like
corridors and hallways.
3.10.4 Fill Light Mode Setting
You can select fill light modes according to your needs. There are three modes:
 Auto: When the photo sensor detects that the ambient environment is not dark, the fill light
is normally off; otherwise, the fill light will be on.