User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Connection and Installation
- 3 System Operations
- 4 Web Operations
- 4.1 Initialization
- 4.2 Login
- 4.3 Resetting the Password
- 4.4 Alarm Linkage
- 4.5 Call Configuration
- 4.6 Data Capacity
- 4.7 Video Setting
- 4.8 Face Detect
- 4.9 Network Setting
- 4.10 Safety Management
- 4.11 User Management
- 4.12 Maintenance
- 4.13 Configuration Management
- 4.14 Upgrade
- 4.15 Version Information
- 4.16 Online User
- 4.17 System Log
- 4.18 Exit
- 5 FAQ
- Appendix 1 Notes of Temperature Monitoring
- Appendix 2 Notes of Face Recording/Comparison
- Appendix 3 Cybersecurity Recommendations
24
IP address configuration
Table 3-6 IP configuration parameters
Parameter
Description
NIC 1/2
Tap to configure parameters for the Ethernet port.
IP Address/Subnet
Mask/Gateway IP
Address
The IP address, subnet mask, and gateway IP address must be on the
same network segment.
DHCP
DHCP (Dynamic Host Configuration Protocol).
When the DHCP is enabled, the IP address can be automatically
acquired, and the IP address, subnet mask and gateway IP address
cannot be manually configured.
P2P
P2P (peer-to-peer) technology enables users to manage devices
without requiring DDNS, port mapping or transit server.
Make sure that the computer used to log in to the web is in the same LAN with the device.
7-inch model X access controllers of have dual NICs. The default management address for
ETH1 is 192.168.1.108, and for ETH2 is 192.168.2.108.
3.9.1.2 Active Register
By active registering, you can connect the access controller to the management platform, and
then you can manage the access controller through the management platform.
Configurations you have made can be cleared on the managing platform, and the access
controller can be initialized, you need to protect the platform managing permission in case of
data loss caused by improper operation.
For active register parameter.
Table 3-7 Active register