User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Connection and Installation
- 3 System Operations
- 4 Web Operations
- 4.1 Initialization
- 4.2 Login
- 4.3 Resetting the Password
- 4.4 Alarm Linkage
- 4.5 Call Configuration
- 4.6 Data Capacity
- 4.7 Video Setting
- 4.8 Face Detect
- 4.9 Network Setting
- 4.10 Safety Management
- 4.11 User Management
- 4.12 Maintenance
- 4.13 Configuration Management
- 4.14 Upgrade
- 4.15 Version Information
- 4.16 Online User
- 4.17 System Log
- 4.18 Exit
- 5 FAQ
- Appendix 1 Notes of Temperature Monitoring
- Appendix 2 Notes of Face Recording/Comparison
- Appendix 3 Cybersecurity Recommendations
39
4 Web Operations
The access controller can be configured and operated on the web. Through the web you can
set network parameters, video parameters, and access controller parameters; and you can also
maintain and update the system.
Initialization
You need to set a password and an email address before logging in to the web for the first time.
Open IE web browser, and enter the IP address (the default address is 192.168.1.108)
of the access controller in the address bar, and then press Enter.
IE 8 and later are supported. Otherwise you might not log in to the web.
Make sure that the computer used to log in to the web is in the same LAN with the
device.
7-inch model X access controllers of have dual NICs. The default IP address for
ETH1 is 192.168.1.108, and for ETH2 is 192.168.2.108.
Initialization
Enter the new password, confirm password, enter an email address, and then click
Next.
The password must consist of 8 to 32 non-blank characters and contain at least
two types of characters among upper case, lower case, number, and special
character (excluding ' " ; : &). Set a password of high security level according to
the password strength prompt.
For security, keep the password properly after initialization and change the
password regularly.