User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Connection and Installation
- 3 System Operations
- 4 Web Operations
- 4.1 Initialization
- 4.2 Login
- 4.3 Resetting the Password
- 4.4 Alarm Linkage
- 4.5 Call Configuration
- 4.6 Data Capacity
- 4.7 Video Setting
- 4.8 Face Detect
- 4.9 Network Setting
- 4.10 Safety Management
- 4.11 User Management
- 4.12 Maintenance
- 4.13 Configuration Management
- 4.14 Upgrade
- 4.15 Version Information
- 4.16 Online User
- 4.17 System Log
- 4.18 Exit
- 5 FAQ
- Appendix 1 Notes of Temperature Monitoring
- Appendix 2 Notes of Face Recording/Comparison
- Appendix 3 Cybersecurity Recommendations
64
Parameter
Description
between the monitored temperature and the actual temperature,
you can correct the temperature deviation by this parameter. For
example, if the monitored temperature is 0.5°C lower than the
actual temperature, the correction value is set to 0.5°C; if the
monitored temperature is 0.5°C higher than the actual
temperature, the correction value is set to -0.5°C.
Only the access controller with a temperature monitoring unit supports
this parameter.
Mask Mode
No detect: Mask is not detected during face recognition.
Mask reminder: Mask is detected during face recognition. If the
person is detected without wearing a mask, the system will
prompt mask reminder and passage is allowed.
Mask intercept: Mask is detected during face recognition. If the
person is detected without wearing a mask, the system will
prompt mask reminder and passage is not allowed.
Click OK to finish the setting.
Network Setting
4.9.1 TCP/IP
You need to configure IP address and DNS server to make sure that the access controller can
communicate with other devices.
Make sure that the access controller is connected to the network correctly.
Select Network Setting > TCP/IP.
TCP/IP
Configure parameters.