Dahua A Series HD Wi-Fi Network Camera Quick Start Guide V 1.0.3 Dahua Vision Technology CO.
1 Packing List Device × 1 QSG ×1 Power Adapter ×1 Screw Package ×1 Quick Installation Board ×1 Installation Position Map×1 1
USB ×1 2
2 Product Appearance Figure 2-1 Figure 2-2 Figure 2-3 Please refer to the following sheet for more details about each port.
Note: For reset, long press for 8 seconds and then the light off; For WPS (Wi-Fi Protected Setup), one quick press. Please refer to the following sheet for more details about status of indicator light. Device status Indicate light status Red light spinning Booting, device malfunction, fail to boot up Green light spinning Booting completed, await Wi-Fi config, enter smart config status; Green light flashing Wi-Fi smart config in progress, including WPS (Wi-Fi Protected Setup), management frame, etc.
3 Operate by Easy4ip APP Step 1 Power on the device with power adapter. Step 2 Connect your smart phone to your Wi-Fi network. Scan the “Easy4ip” QR on the packing box, download and install the Easy4ip APP. Step 3 Open Easy4ip APP (take IOS as an example), tap “Login” to login the APP, see Figure 3-1. Please register an account for your first use. Figure 3-1 Step 4 Please tap “+” to add new devices after you log in your account.
Figure 3-2 Step 5 Scan the QR code on the back of the camera to get the SN, you can also tap “Continue without scanning” and manually input the SN number on the next page.
Figure 3-3 Step 6 Fill in the Username and Password of the new camera, both of which are admin by default.
Figure 3-4 Step 7 Select “Yes, config Wi-Fi”, and fill in your Wi-Fi password, then tap “Next”. During the Wi-Fi connecting process, please put your smartphone and the camera within 30cm.
Figure 3-5 Figure 3-6 Step 8 Your Camera will be added to your account.
Figure 3-7 Note: If you have more cameras, please follow steps 4-8 to add them one by one. If you want to change the Wi-Fi signal, please reset the camera to factory default and repeat steps 4-8 to add the device.
4 Device Installation Important Before the installation, please make sure the installation environments can at least support 3x weight of the camera. Figure 4-1 Note: This quick start guide is for reference only. Slight difference may be found in user interface. All the designs and software here are subject to change without prior written notice. All trademarks and registered trademarks mentioned are the properties of their respective owners.
5 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.