Quick Start Guide

Installing Camera
Make sure that the mounting surface is strong enough to hold
at least three times of the device weight.
Expansion Bolt
Camera
About the Guide
- This quick start guide is for reference only. Minor difference might
be found in user interface.
- All the design and software here are subject to change without
prior written notice.
- All trademarks and registered trademarks mentioned are the
properties of their respective owners.
- Please visit our website or contact your local service engineer for
more information.
- If there is any uncertainty or controversy, please refer to our final
explanation.
Alarm Input/output
The camera can connect to external alarm input/output device
through digital input/output.
Device collects different states of alarm input port when the input
signal is idling and being grounded.
Device collects logic "1" when input signal is connecting to +3V to
+5V or idling.
Device collects logic "0" when input signal is grounded.
Mode A: Level application. Alarm outputs high and low level, and
the alarm outlet is OD, which requires external pull-up resistance
(10K Ohm typical) to work. The maximum external pull-up level is
12V, maximum port current is 300mA and the default output signal is
high level (external pull-up voltage). The default output signal
switches to low level when there is alarm output (As long as the
operating current below 300mA, the output low level voltage is
Step 1
Step 2
Connect alarm output device to the alarm output end of the
I/O port. The alarm output is open-drain output, which works in
the following modes.
Mode B: Switch application. Alarm output is used to drive external
circuit, the maximum voltage is 12V and the maximum current is
300mA. If the voltage is higher than 12V, please use an additional
electric relay.
Step 3
Log in to web interface, and configure alarm input and alarm
output in alarm setting.
The alarm input on the web interface is corresponding to the
alarm input end of the I/O port. There will be high level and low
level alarm signal generated by the alarm input device when
alarm occurs, set the input mode to "NO" (default) if the alarm
input signal is logic "0" and to "NC" if the alarm input signal is logic
"1".
The alarm output on the web interface is corresponding to the
alarm output end of the device, which is also alarm output end
of the I/O port.
Loosen the adjust knob and adjust the camera to a
proper surveillance position as needed.
Secure the adjust knob to fix the camera.
Note:
Step 1
Step 2
Step 3
Step 4
Step 5
Drill screw holes on the mounting surface as the
positioning map shows, and then put in the expansion
bolts.
Attach the camera pedestal to the mounting
surface with the self-tapping screws.
Connect the cable and start the camera.
Connecting
Connect alarm input device to the alarm input end of the I/O port.
See the following picture.
Adjust Knob
Self-tapping Screw
Mounting Surface
Positioning Map