DH-PFM889 Series Wireless Device Quick Config Manual V1.0.0 Zhejiang Dahua Vision Technology Co.
Important Safeguards and Warnings Please read the following safeguards and warnings carefully before using the product in order to avoid damages and losses. Attentions: Do not expose the device to lampblack, steam or dust. Otherwise it may cause fire or electric shock. Do not install the device at position exposed to sunlight or in high temperature. Temperature rise in device may cause fire. Do not expose the device to humid environment. Otherwise it may cause fire.
Table of Contents 1 Cable Connection ............................................................................................................ - 3 - 2 Typical Working Mode ................................................................................................... - 4 - 3 Device Config ................................................................................................................... - 5 - 4 Appendix 1 Technical Specifications ................................................
1 Cable Connection Please refer to Figure 1-1 for the connection of DH-PFM889. Figure 1-1 Please refer to sheet 1-1 for more details about the port. Device model Port Port name Connection and function DH-PFM889-I 3 RJ45 ports PoE Connect to the “PoE” on the PoE power device via twisted pair, and provide power and data transmission to the device. LAN “LAN” port can be used to connect to IP camera, you can select any LAN port for device debugging.
2 Typical Working Mode The product can provide excellent wireless signal coverage, which can be widely applied in various indoor scenes, such as office, meeting room, coffee shop, restaurant, hospital lobby, airport hall and other areas with high people density.
3 Device Config Precondition Please refer to the cable connection figure to connect the device to mainframe and power it on. Operation Steps It is to configure access point device via the following steps, the terminal users can be connected and communicated after config is completed. Step 1 Configure the computer IP address as the address which is not used in the LAN, such as 192.168.1.180.
Figure 3-2 Step 4 Click the wizard column and the interface is shown as below. Here you can modify the router password and select interface language. Figure 3-3 Step 5 Click “Next” and the interface can be used to set the network working mode of the device. Please use bridge mode if the device is used as access point, besides, please modify LAN IP in order to avoid conflict. The device can be used as a router after selecting route mode.
Figure 3-4 Step 6 Click “Next” and the interface is used to set the wireless mode of the device.
Figure 3-5 Attention: Please configure different “channel” for different access points when it is deployed with multi access ponit, which is to avoid the disturbance between devices. Please turn off TDMA function when it is connected to general clients such as laptop, mobile phone and wireless camera.
4 Appendix 1 Technical Specifications Item DH-PFM889-I DH-PFM889-IM IEEE802.11 b/g/n IEEE802.11 a/n/ac（2T2R） （2T2R） IEEE802.
Network mode Route/bridge Security mechanism IP/MAC address filter, conceal network name, port isolation.
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
