Quick Start Guide
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Introduction
- 2 Start and Shutdown
- 3 Quick Configuration
- 4 System Configurations
- 4.1 Preview
- 4.2 Playback
- 4.3 TV Wall
- 4.4 Platform
- 4.5 PTZ Control
- 4.6 Settings
- 4.7 Extension
- Appendix 1 Cybersecurity Recommendations
System Configurations 35
This part also applies to TV wall device.
Enter IP address of matrix at address bar of the browser, and then press Enter. Step 1
Matrix login interface is displayed. See Figure 4-23.
Matrix login interface Figure 4-23
Enter username and password. Step 2
Click Login to enter web interface. Step 3
4.3.1.1 Adding Network Signal
Search or add network signals manually.
Select Setup > Signal Management > Network Signal. Step 1
The Network Signal interface is displayed. See Figure 4-24.
Registration Figure 4-24
Add network signals. Step 2
Click Device Search to show search results, select the needed device and then
click Add.
Click Add to set parameters in the pop-up dialog box.