User's Guide

Environment Requirements

Place Requirements

Filament Requirements

Filament Storage

Legal Notice

The device must be placed in a dry and ventilated environment.

The distances of the left, right and back side space should be at least 20cm, and

the distance of the front side space should be at least 35cm. Device storage

temperature: RT 0-40℃

Do not abuse the filament. Please make sure you use the FlashForge filament or

the filament from the brands accepted by FlashForge.

Nozzle clogging and damage may be caused by non-FlashForge filament due to

inappropriate material properties.

All polymers degrade with time. Do not unpack filament until necessary. Filament

should be stored at clean and dry conditions.

Temperature: RT 15-30℃; Moisture: 20%-70%

All the information in this document is subject to any amendment or change

without the official authorization from FlashForge.

FLASHFORGE CORPORATION MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS

DOCUMENT, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRATIES OF MERCHANTABILITY

AND FITNESS FOR A PARTICULAR PURPOSE.

FCC Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

FlashForge shall not be liable for errors contained herein for incidental consequential

damages in connection with furnishing, performance or use of this material.

This document contains proprietary information protected by copyright.