User's Manual

Hunter User Guide | www.flashforge.com 0086- 0579-82273989
29
Method 6: Select and drag the target file to the icon of Flashprint.
Note: .STL, .SLC,.OBJ, .3MF and .FPP, ways to store 3D models, are supported by
Flashprint for editing.
Generating Rilievo
Loading a png, jpg, jpeg, bmp picture file into the FlashPrint. And the following
dialogue box(5-4) will pop up. The setting box includes settings for shape, mode,
maximum thickness, base thickness, bottom thickness,width, height, top diameter and
bottom diameter.
Shape: including plane, tube, canister and lamp.
Mode: including “darker is higher”and “lighter is higher”.
Maximum thickness: Z value of the model
Base thickness: The minimum raft thickness and the default value is 0.5mm
Width: X value of the model
Depth: Y value of the model
Bottom thickness: For tube, canister, lamp and stea to set up bottom thickness
Top diameter: For tube, canister, lamp and stea to set up the top diameter
Bottom diameter: For tube, canister, lamp and stea to set up the bottom diameter
5-4