User's Manual
Table Of Contents
Hunter User Guide | www.flashforge.com 0086- 0579-82273989
38
5.2.10 Print
5-12
①
Preview: Choose to enter preview interface or not
② Print when slice done: Print or not when slice done
③
Material type: Choose according to the type of model
④
Save as new: To custom the material type and remember this choice.
⑤ Remove: Clear the custom material type.
⑥
Layer height: To set the height of each layer while printing, the default value is
0.025mm, optional values are 0.05mm. The higher value with lower printing precision
and higher speed, and vice versa.
●Expose time
a. Base time: To set expose time to solidify a layer of photopolymer resin.
b. Attach time: To set the expose time that solidify the attached a layer of
photopolymer resin.
c. Raft: To choose whether print the raft.
● Size adjust