User's Manual

Hunter User Guide | www.flashforge.com 0086- 0579-82273989
49
7. A list of file(s) will show up, press the file that you would like to print, then press
[ Yes ].
8. The printer will now enter preheating phase and will start printing once it finishes
preheating
Printing via Wi-Fi
After the printer and computer have connected wifi (Please refer to 5.2.13 ), load the
Gecod file in Flashprint, then click [Print] icon to start printing.
Notice: Please close the cover while printing.
6.3 Model Processing
(6-6)After finish printing, please put on vinyl gloves and open the light shield,
hold the build plate and unscrew the platform screw, take out the build plate from
horizontal direction carefully.
Attention: Please put on vinyl gloves during operation,
Pour the used photopolymer resin into a clean bottle, it can be recycled.
Photopolymer resin need to be stored in a dark, dry and cool place.
6-6
(6-7) Pour the iso phthalic acid(IPA) in to rinse bucket halfway, immerse the build
plate and model into rinse bucket and rinse it with brush.