User Manual

InventorⅡ
InventorⅡ
User Guide |
User Guide |
www.f
lashforge.com
lashforge.com
14
Tools in print interface
Ÿ
Filament: To change filament during
printing.
(Note: You need to suspend the operation
first)
Ÿ
Finish
Ÿ
Cancel: To end the tool orders and
to the print interface.
Tap the [Preheat] button to enter the preheat
interface. Tap the [Start] button to heat up to
the setting temperature.
The default temperature is 220. ℃
Tap the temperature display bar to set the
temperature.
To set the preheat temperature.
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
Tools in print interface
Filament: To change filament during
printing.
(Note: You need to suspend the operation
first)
Finish
-
Shut: To start auto shutdown
Cancel: To end the tool orders and
to the print interface.
Tap the [Preheat] button to enter the preheat
interface. Tap the [Start] button to heat up to
the setting temperature.
The default temperature is 220. ℃
Tap the temperature display bar to set the
temperature.
To set the preheat temperature.
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
0086-
0579
Tools in print interface
Filament: To change filament during
(Note: You need to suspend the operation
Shut: To start auto shutdown
Cancel: To end the tool orders and
to the print interface.
Preheat
Tap the [Preheat] button to enter the preheat
interface. Tap the [Start] button to heat up to
the setting temperature.
The default temperature is 220. ℃
Tap the temperature display bar to set the
To set the preheat temperature.
Tap [Yes] to save the setting while tap [No]
to cancel the setting.
0579
-82273989
Filament: To change filament during
(Note: You need to suspend the operation
Shut: To start auto shutdown
Cancel: To end the tool orders and
return
Preheat
Tap the [Preheat] button to enter the preheat
interface. Tap the [Start] button to heat up to
The default temperature is 220. ℃
Tap the temperature display bar to set the
To set the preheat temperature.
Tap [Yes] to save the setting while tap [No]
Filament: To change filament during
(Note: You need to suspend the operation
return
Tap the [Preheat] button to enter the preheat
interface. Tap the [Start] button to heat up to
Tap the temperature display bar to set the
Tap [Yes] to save the setting while tap [No]