User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
17
Servo On:
Actually, the present servo status is off.
And the servo’s swing arm withdraws.
Tap ‘+’ or ‘-’ to adjust the status of swing
arm. Tap ‘+’, the arm swings down while
tap ‘-’ , the arm swings up.
Servo OFF:
Actually, the present servo status is on.
And the servo’s swing arm withdraws.
Tap ‘+’ or ‘-’ to adjust the status of swing
arm. Tap ‘+’, the arm swings down while
tap ‘-’ , the arm swings up.
WIFI:
ŸReset: Reset the WIFI
ŸTurn on WIFI: Turn on the WIFI,
release the WIFI hotspot and set the
WIFI on computer
ŸReturn arrow
Printhead Adjust:
After the build plate and extruder
finish the initial movement, you can
tap ‘+’or ‘-’ to adjust the distance
between the build plate and nozzle.
Z：0. 00 stands for the position where
the servo is precisely triggered.