User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
19
Chapter 3: Hardware Assembly
Your Inventor Ⅱhas been installed before leaving factory, you can start up the
InventorⅡ for printing after mounting the filament spool and completing leveling.
3.1 Filament Installation
3-1
(3-1) The filament cartridge is at the rear of InventorⅡ. Lift the cartridge out of the
InventorⅡ.
3-2
(3-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feeds from the bottom of the spool towards the top )
After installing the filament, put the cartridge back to the printer.
3.2 Printer Start-up
3-3
Black Filament Detecting
Equipment
pwoer Power in