User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989

5.2.7 Scale

Select the target object and scale the object by the following two methods:

Method 1: Click the [Scale] icon on the left, hold down the left mouse button and

scale the model. The corresponding values will display near the object.

Method 2: Click the [Scale] icon on the left and then enter into scale values in X/Y/Z

axes positioning. Click the [Maximum] button to get largest size possible for building.

Click [Reset] to reset the size of model.

Note: If the [Uniform Scaling] radio button is clicked, it will scale the model in equal

proportion when changing value in any positioning of the model. Otherwise it will

only change the value of the corresponding positioning.

5.2.8 Cut

Left-click on the model to select it and double-click on the Cut icon to set the cut

plane. The direction and position are available for setting.

Draw with Mouse①

X Plane②