User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
40
Material type:③ Choose according to the type of model
Supports:④ When print suspended structure models, support is necessary. Click
[supports] to create support part for the printing.
Raft:⑤ This function will help the model to stick well on the platform.
Wall:⑥ During dual color printing, this function will help to clear the leaking
filament of another extruder.
Vase Mode: ⑦ No capping for the model
Resolution⑧ ：You have three resolution solution(with default setting)to choose from,
high resolution is corresponding with slow printing speed, opposite for the low
resolution. For PLA printing, an extra solution “Hyper” is available.
More options:⑨ Click [More options] to set for layer, shell, infill, speed and
temperature. Different resolution solution is corresponding to different defaults, click
[Restore Defaults] to back to default setting.
●Layer
a. Layer: Layer thickness of the printing model. With a small value, the surface
of the model will be more smooth.
b. First Layer Height: This is the first layer of the model, which will affect the
sticking performance between the model and platform. Maximize is 0.4mm, usually
the default is ok.
c. Shell: Contains the outside shell value, capping layer value (under vase pattern,
top solid layer setting is invalid.)
● Primeter Shells: Maximize is 10
a. Top Solid Layer: Maximize is 10, minimum is 1.
b. Bottom Solid Layer: Maximize is 10, minimum is 1.
● Infill