User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989

a. Fill Density means fill rate.

b. Fill Pattern is the pattern of filling shape which effects printing duration.

c. Combine Infill: You can select the layers for combining according to the layer

thickness. The combined thickness should not exceed 0.4mm. “Every N layers” is for all the

infills while “Every N inner layers” is only for inner infills, which generally can save print

time.

5-13

● Speed

a. Print Speed is the moving speed of the extruder. Generally, the lower speed is,

the better print you will get. For PLA printing, 80 is recommended.

b. Support Print Speed is needed to set when choosing Slic3r as the

slice engine which can control the moving speed of the extruder when printing

the supports.

c. Travel Speed is to control the moving speed of the extruder under non-printing

Status during work. For PLA printing, 100 is recommended.

Note: Modify parameters settings to get better prints as different models need different

parameters.

● Temperature

Extruder Temperature: Recommended extruder temperature is 220.℃

Note: Different temperatures have subtle influences in prints. Please adjust the

temperature according to the condition in order to get a good print.

● Others

Pause At Heights: Allows users to pre-set a height in which the print will

suspend automatically. The function usually applied when you want to change the