User Manual
InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
46
Method 1:Connect Via USB Cable
a. Connect your InventorⅡ with your PC via an USB cable.
b. Turn on your InventorⅡ and start Flashprint.
c.Click [Print]--[Connect Machine], then select USB in the [Connection Mode]
option and select machine you want to connect in [Select Machine] option. If you can
not find your machine, click the [Rescan] button to scan your machine and select it.
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, it means you haven’t installed the driver in the software.
5-18
Method 2: Connect Via WIFI
Connect ① InventorⅡ with your PC under AP mode
a.Turn on your InventorⅡ
b.Tap [Tools]-[Setting]-[WIFI]-[WIFI ON]
c. Click on the wireless network on the left bottom, and find the wireless
signal-“InventorⅡ”. Click [Connect] to finish network connection.
d. Click[Print]-[Connect Machine] on Flashprint. Then the following dialog box
pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].