User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989

● Temperature Control: Input the temperature you want to get in the left frame, click

[Apply], the printer will automatically heat the corresponding part, the right side

shows the current actual temperature of corresponding part. After starting heating, the

below curve of temperature form will start to change, different color correspond

different parts’ temperatures

② Update Firmware

Every time when you start Flashprint, it will automatically detect and download the

up-to-date firmware. If any update is available, a dialog box will pop up for reminding

the users to update.

Step 1: Click [Tools]--[Update firmware]. It needs to cut off connection before

updating firmware. If software and printer are already in connection, it reminds you

cutting off the connection, choose [Yes] and go on to the next step.

Step 2: Choose corresponding printer type and firmware version and click [OK] in the

firmware updating box. After confirming the printer is in free state, the software will

automatically update the firmware

5-24

Step 3：Reboot you InventorⅡ and wait for 4-5 seconds, then you can see the update

process bar. When the update finishes, it will go back to the main interface.

Step 4：Tap[Tools]--[About] to check] to check whether the updated version is right.