User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
57
If you want to print a Gcode from a local folder, you just need to load the file into
Flashprint at the status of USB connection or WIFI connection, then click the [Print]
button on the top-right.
● Load the target Gcode file into FlashPrint.
6-9
● Click the [Print] button, the PC will transfer the Gcode file to the printer.
7-10
● After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.