User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
63
Support
1）General
a. Enable Support: Allows users to turn on/off the support option. Support structure
can prevent the model from collapsing. If choosing “Yes”, then both treelike and linear
supports are available for setting up. If choosing “No”, then both treelike and linear
supports are unavailable for setting up.
2）Treelike
a. Speed: Speed at which the treelike supports are printed.
b. Space to Model(X/Y): The gap between the treelike supports and the model contact
surface (in the X/Y directions).
c. Shell Count: To control the printing laps for support’s outer shell.
3）Linear
a. Speed: Speed at which the linear supports are printed.
b. Space to Model(X/Y): The gap between the treelike supports and the model contact
surfaces (in the X/Y directions).
c. Space to Model(Z): The distance between the treelike supports and the model
contact surface (in the Z direction).
d. Path Space: The distance between the adjoining paths.
8
-
5