User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989
66
Max:125% (Usually the default ratio is suggested)
b. Path Width: The width of the path, the default value is 0.4mm. Keeping default is
suggested.
c. Path Resolution: The default value is 0.1mm. The bigger the value is, the lower the
extrusion resolution is. On the contrary, the extrusion resolution is much higher.
Others
Dimensional Adjustment
a. Enable Adjustments: Enable software to make compensation for errors.
b. External Compensation: Enable software to make compensation for the outer
diameter error.
c. Internal Compensation: Enable software to make compensation for the inner
diameter error.
7-8
7-7
带格式的:
字体: (默认) Times New
Roman