Users Manual

(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which
the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2AYEO-HW3000 Or Contains FCC ID: 2AYEO-HW3000”
when the module is installed inside another device, the user manual of this device must contain below warning statements;
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
The device has been evaluated to meet general RF exposure requirement. The devicecan be used in portable exposure condition without restriction.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
The devices must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that
comes with the product
Any company of the host device which install this modular with limit modular approval should perform the test of radiated emission and
spurious emission according to FCC part 15C : 15.231 and 15.209 requirement,Only if the test result comply with FCC part 15C : 15.231 and
15.209 requirement，then the host can be sold legally.
The FCC rule/s for this module are CFR 47 Part 15 Subpart C.
This modular transmitter is only FCC authorized for the specific rule parts listed on its grant. The host product manufacturer is responsible to
any other FCC rules that apply to the host not covered by the modular. transmitter grant of certification. The final host product will require Part
15 Subpart B compliance when the modular transmitter is installed.
The module may be operated only with the integral chip antenna with which it is authorized.
Additional testing and certification may be necessary when multiple modules are used.
Any modifications made to the module will void the Grant of Certification, this module is limited to OEM installation only and must not be sold
to end-users, end-user shall have no manual instructions to remove or install the device, only software or operating procedure shall be placed
in the end-user operating manual of final products.