User's Manual
Table Of Contents
- Q7S Fingerprint password smart lock User Manual
- Installation instructions
- Restoring Ex-factory Settings (Initialization System)- Operation on Power Up
- Administrator action settings
- Unlock
- Lock lock
- Electronic backlock
- doorbell
- Electricity alarm
- Battery charging and system emergency
- Continuous validation error freeze
- System exception handling
- Get WeChat Whip (dynamic password)
- Dynamic Cryptography Knowledge Dialysis
- The Principle of Dynamic Cryptography
- Number of times
- Short Time Password
- Long time limit password
- List of Products and Accessories
- Declaration
- Disclaimer
- Door
4. Add Equipment
Return to "device list ", click "+" in the upper right corner to add the
device, as shown below; add the device for the first time, need to create the
home, enter the name of the home, click again on the upper right corner "+".
4.1: Connected device hotspots
Enter this interface, wait, do not click "next ", please WeChat back to the
background;
Operation lock into the WIFI hot network state, wake up lock a light press
"2#" to verify the administrator information.
Turn on the phone to set up a WIFI to connect to the CloudHome-XXXX-16 WIFI, after the
successful connection to WeChat public number, click on "next ";
Note: some mobile phone Wi-Fi list refresh is slow, please refresh or click on
the Wi-Fi switch key to force refresh; the hot Wi-Fi sent out by the device can
not access the Internet, some mobile phones may be prompted to switch the network,
Select ignore, do not switch, continue to use, etc. If the connection is
successful, there will be a language broadcast, but the phone prompt is successful,
and the lock does not reflect, the network is actually connected, direct 4.2:
select the WIFI to connect
4.3: Enter the correct WIFI password
4.4: Networking
4.5: Registration of new equipment