User's Manual
Table Of Contents
- Q7S Fingerprint password smart lock User Manual
- Installation instructions
- Restoring Ex-factory Settings (Initialization System)- Operation on Power Up
- Administrator action settings
- Unlock
- Lock lock
- Electronic backlock
- doorbell
- Electricity alarm
- Battery charging and system emergency
- Continuous validation error freeze
- System exception handling
- Get WeChat Whip (dynamic password)
- Dynamic Cryptography Knowledge Dialysis
- The Principle of Dynamic Cryptography
- Number of times
- Short Time Password
- Long time limit password
- List of Products and Accessories
- Declaration
- Disclaimer
- Door
Installation instructions
Install the safety bar on the back panel, the square bar only needs to insert the bolt
slot vertically, the opening pin can not be pulled out.
Figure 1:indoor outdoor
Take out the handle connecting pipe and connect the front panel wire to the front panel
through the facade and lock body (the correct position of the wire is: the lock hole at
the top of the door fan) and insert the square bar into the security door lock body,
usually with a short end facing inward.
Insert the front panel wire in the rear panel;
2. The rear panel insurance is aligned with the safety hole;
3. The handle knob is aligned inward and the rotary knob is aligned with the square
s
teel of the lock core.
Do not tighten the screw too tight, move the rear panel, press the knob inward to turn the
knob more freely before tightening the connecting screw.
Install lithium battery, cover battery cover and install.
Door