User's Manual
Table Of Contents
- Q7S Fingerprint password smart lock User Manual
- Installation instructions
- Restoring Ex-factory Settings (Initialization System)- Operation on Power Up
- Administrator action settings
- Unlock
- Lock lock
- Electronic backlock
- doorbell
- Electricity alarm
- Battery charging and system emergency
- Continuous validation error freeze
- System exception handling
- Get WeChat Whip (dynamic password)
- Dynamic Cryptography Knowledge Dialysis
- The Principle of Dynamic Cryptography
- Number of times
- Short Time Password
- Long time limit password
- List of Products and Accessories
- Declaration
- Disclaimer
- Door
Serial
number
Project Description
1 Working voltage 7V-8.4V
2 Alarm voltage Below 7.2 V: battery power
3 dormant static current <80|JA
4 Formula Fingerprint, aim, card
5 NFC
6
Mouth
Micro USB interface
(Charger charging battery)
7
Number of users managed
5
8
Number of ordinary users
295
9
Reference
100
10
100
11
Number of cards
100
12
Card Type and Type
Mifare-l and ISO /IEC 11143-A
compatibility
13
Lock (front panel)
Lakes (CLOSE)
14
^± lock (rear panel)
(CLOSE)
15 (rear panel) Lakes (OPEN)
Restoring Ex-factory Settings (Initialization System)- Operation on
Power Up
1、 Remove all batteries from the intelligent lock and disconnect the power
supply during testing.
2、 Multiple clicks on the rear panel switch lock key to allow the system
to discharge completely.
3、 Press the rear panel lock key not to loosen, put in the intelligent lock
battery.
4、 Wait for the system to prompt 5 keystroke sounds (release fingers within