Remote controller Control box USER’S MANUAL
I.
II. PAIRING THE WIRELESS REMOTE STEP 1: STEP 3: Push in on bottom of remote to release battery cartridge and install three AAA batteries into the remote battery compartment.Push in firmly to then press “HEAD UP”, never release until the backlight LED close. is lighting all long, the remote is pairing and release it.
III. FUNCTIONAL OPERATING FOR WIRELESS REMOTE MARK STEP1 STEP2 DESCRIPTIONS FUNCTION The backlight LEDs all OFF before operating. TV Press(TV,ZG)until the backlight LED is lighting and the memory position is completed. MEMORY the corresponding memory position. POSITION ZG When the backlight LED is lighting and press again, clear TV & ZG have the memory position.
IV. FUNCTIONAL OPERATING FOR WIRELESS REMOTE Power supply Controll box Power supply: Input: 100-240V ~, 50/60Hz Output:29.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.