Specifications

FCC Statement:

Please take attention that changes or modification not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator &

your body.

(1) Operational use conditions

Module has professional users use condition limitations, Host product manufacturer please ensure

giving such warning like “Product is limited to professional users use” in your product’s instruction.

(2) Antenna used

Antenna type Max. Antenna Gain

2.4G Wi-Fi PCB Antenna

Antenna 1: 0.91dBi

Antenna 2: 1.18dBi

5G Wi-Fi PCB Antenna

Antenna 1:

U-NII-1: 0.45dBi

U-NII-3: -1.03dBi

Antenna 2:

U-NII-1: -0.92dBi

U-NII-3: -1.69dBi

(3) Labelling Instruction for Host Product Integrator

Please notice that if the FCC identification number is not visible when the module is installed inside

another device, then the outside of the device into which the module is installed must also display a

label referring to the enclosed module. For FCC, this exterior label should follow “Contains FCC ID:

2AL8S-0302C3XN-2”.

§15.19 and RSS-Gen Labelling requirements shall be complied on end user device. Labelling rules

for special device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For E-label,

please refer to §2.935.

(4) Installation Notice to Host Product Manufacturer

The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove

or install module.

The module is limited to installation in mobile application, a separate approval is required for all other

operating configurations, including portable configurations with respect to §2.1093 and difference

antenna configurations.

(5) Antenna Change Notice to Host manufacturer

If you desire to increase antenna gain and either change antenna type or use same antenna type

certified, a Class II permissive change application is required to be filed by us, or you (host

manufacturer) can take responsibility through the change in FCC ID and IC ID (new application)

procedure followed by a Class II permissive change application.