User Manual
Table Of Contents
- Packing List
- Get to Know CRANE-M2
- Charging Procedure
- Installation and Balancing
- Balance Adjustment Method
- Smartphone Installation
- GoPro Camera Installation
- How to Use
- Display Screen Description
- Micro USB Power Outlet Usage
- Manual Angle Lock
- Control Mode Description
- Motor Torque Adjustment
- Menu Option Description
- APP Operations
- Calibration and Firmware Upgrade
- Six-Side Calibration
- Firmware Upgrade
- Motor Fine-Tuning
- Calibration and Firmware Upgrade
- Product Specifications
- Disclaimer and Warning
- Warranty Terms
- Contact Card
19
Initialization Method
Turn on the stabilizer and long press the Mode Button to enter into Standby mode. Put
the stabilizer on a flat surface and wait for about 30 seconds. The stabilizer will finish the
initialization process automatically.
Calibration and Firmware Upgrade
When do you need to calibrate the stabilizer?
Please calibrate the stabilizer when necessary.
When How
1. Slight deviation is found in the tilt angle of the camera in level position
after turning on.
2. Slight deviation is found in the roll angle of the camera in level position
after turning on.
3. Frequent small angle correction is found when the camera is in level
position while the stabilizer stays still.
Initializing
the
stabilizer
1. Slight deviation is found in the level position after the initialization of the
stabilizer.
2. The stabilizer has not been used for a long time.
3. The stabilizer undergoes significant temperature difference in operation
environments.
Six-side
calibration
Slight deviation is found in the tilt or roll angle of the camera in level
position after initialization and six-side calibration of the stabilizer.
Fine tuning
the motors