User Manual

6
Battery Installation
Slide out the cover of the battery compartment
and load two ZHIYUN 18650 lithium batteries
(note the positive and negative directions).
Camera Installation
a. Take out the quick release plate module and press the Quick Release Button
to take out the Arca quick release plate.
b. Mount the camera on the backing base as above, then mount it on the
quick release plate and tighten the 1/4’’ screw at its bottom.
c. Adjust the lens support on the quick release plate to support the lens and
ensure it is stable.
d. Mount the installed quick release plate into the quick release module, and
then install and lock the whole module on the three-axis stabilizer.
1. Before mounting the camera, make sure it is prepared ahead of time.
Remove the lens cap and make sure the camera’s battery and memory
card are already in place.
2. The backing base is needed when the size of the lens outranges the
bottom of the camera. You can decide whether to install the backing
base according to the actual situation.
Installation