User Manual

20
When to Calibrate the Stabilizer
Initialization Method
1. Correctly install the batteries.
2. Hold the camera mounting plate with one hand, long press the power
button to start up the stabilizer; long press the POV mode button to enter
standby mode while keeping hold of the camera mounting plate through
the whole process in case of start-up failure.
3. Put the stabilizer still on a table surface, and wait for about 30 sec, and the
stabilizer will automatically complete initialization.
Syndromes that requires calibration
How to
calibrate
1. Slight deviation is found in the tilt angle of the camera in
level position after startup.
2. Slight deviation is found in the roll angle of the camera in
level position after startup.
3. Frequent small angle correction is found when the camera
is in level position while the stabilizer stays still.
Initializing the
stabilizer
1. Slight deviation is found in the level position after the
initialization of the stabilizer.
2. The stabilizer has not been used for a long time.
3. The stabilizer undergoes significant temperature difference
in operation environments.
Six-side
calibration
Slight deviation is found in the tilt or roll angle of the camera
in level position after initialization and six-side calibration of
the stabilizer.
Fine tune
motor force
Please calibrate the stabilizer when necessary.
Calibration and Firmware Upgrade