Specifications

6381-A4 Router Users Guide 97
The Apply button will temporarily save this connection. To make the change permanent, click
Tools (at the top of the page) and select System Commands. On the System Commands
page, click Save All.
Ingress Layer 2 Configuration
Layer 2 page enables you to map an incoming packet with VLAN priority to CoS. This feature is
only configurable on the WAN interfaces as VLAN is only supported on the WAN side in the
current software release.
Interface
Select the WAN interface here to configure the CoS for incoming traffic. Only
WAN interface can be selected as VLAN is currently supported only on the WAN
side.
Class of Service
The selections are (in the order of descending priority): CoS1, CoS2, CoS3,
CoS4, CoS5, and CoS6.
User Priority
The selections are 0, 1, 2, 3, 4, 5, 6, 7.
To configure Ingress Layer 2 to CoS:
1. From Interface drop-down box, select PPPoE to configure QoS on this WAN interface.
2. Select CoS1 in Class of Service and 5 in Priority Bits.
Any packets with priority marking 5 is mapped to CoS1, the highest priority that is normally
given to the voice packets.
3. Click Apply to temporarily activate the settings.
4. Select CoS2 in the Class of Service field and 1 in the Priority Bits field.
Any packets that have priority bits of 1 are mapped to CoS2, which is the second highest
priority. This is given to the high priority packets such as video.
5. Click Apply to temporarily activate the settings.