User`s manual
BitStorm L3S Series Device Manager
Console version
The Console version of the BitStorm L3S Series Device Manager can be used to:
Configure the system, including password changes and the Spanning Tree Protocol
●
Configure all ports●
Create port-based VLANs●
Configure IP routing●
Configure SNMP settings●
Reach the Command Line interface●
Reset the system●
The Console Main Menu items are described below.
System Setup:
change the existing password
●
update system firmware●
reset the Switch to the factory defaults●
System Configuration:
name your Switch, enter contact and location
●
set its IP address, subnet mask and default gateway●
check the Switch's uptime●
set a trap level●
view the Switch's hardware, software and boot ROM versions●
Set Port Configuration:
configure individual ports
●
name ports●
96