User's Manual

2、Volume adjustment:
Click the “+”、“-”button to adjust the volume. You can hear the prompt tone if
the signal is lost,and it continues until it enters the power saving mode,you can
click any button to turn it off. Note: There will be no prompt tone if the transmitter
is turned off to lose the signal.
Attention:
1、When the transmitters and receivers are not used for a long time,please charge them once
every 3 months,so that the batteries can be protected. (There is lithium battery inside the
device, if it was not used or charged for a long time,the battery would be damaged.)
2、If the devices are the first time used for the tour companies or the tourist attractions,please
reset a relatively complicated channel number for them(don’t use the default channel), so that
the crosstalk problem caused by the same channel used by different tourist teams in the same
place can be avoided.
User instruction of Charging case
Use the ATG - C32, ATG - popular C64, ATG - CG32, ATG - 16 recharge the above equipment.
ATG - C32, ATG - popular C64, ATG - CG32, ATG - 16 charging equipment use of the note below
1、Power supply：AC 90V--250V
2、When it is going to be charging,take the foam out,and keep the cover
open .
3、Normally it takes about 3 hours to charge the receivers full,and it
takes about 6 hours to charge the transmitters full.
P.S: If you use the single charger to charge the device, it takes about 2 hours
to charge the receiver full,and it takes about 4 hours to charge the transmitter
full.