User's Manual

GB-14
Other features
Set the alarm timer
You can set two alarms which go off at different
time.
1. Press and hold ALARM 1 or ALARM 2
button.The hour digits begin to blink, [ALM
SET], [
1] or [ 2] ashes on the screen.
2. Press
I
/
J
button repeatedly to set the hour.
3. Press OK button to conrm, the minute digits
begin to blink, [ 1] or [ 2] ashes on the
screen.
4. Repeat steps 2-3 to set the minute, select
when to ring alarm, and choose alarm sound
source and alarm volume.
Note:
* If you select DOCK 1/DOCK 2, USB as alarm
sound source, when there is no device docked,
the alarm will automatically switch to buzzer
to ring the alarm.
* If both alarms are set to the same time, only
Alarm 1 will ring.
View the alarm settings
Press ALARM1 or ALARM2 to view alarm
settings.
Activate / deactivate alarm timer
When an alarm setting is shown on the screen,
press AL 1 or AL 2 repeatedly to activate or
deactivate the alarm timer.
- If the timer is activated, [ 1] or [ 2] is
displayed.
- If the timer is deactivated, [ 1] or [ 2] is
disappears.
Snooze alarm
When alarm sounds, press SNOOZE, the alarm
snoozes and repeats ringing 9 minutes later.
Stop alarm ring
When an alarm rings, press the corresponding
STANDBY, SOURCE, ALARM 1 or ALARM 2.
The alarm stops but the alarm settings remain.
Set the sleep timer
This clock radio can switch to standby mode
automatically after a preset period.
* Press SLEEP repeatedly to select the sleep
timer period (in minutes), when the sleep
timer is activated, SLEEP appears.
* To deactivate the sleep timer, press SLEEP
repeatedly until [OFF] (off) appears.
Adjust display brightness
Press BRIGHTNESS button repeatedly to select
different levels of display brightness.
● If no time signal is received, [NO CT] is
displayed.
Note:
* The accuracy of the transmitted time depends on the RDS station that transmits the time signal.