User's Manual

To disconnect the Bluetooth function, you can :

- Switch to another function on the unit.

- Disable the function from your Bluetooth device.The Bluetooth device will be disconnected from

the unit after the “Disconnected” voice prompt.

- Press and hold the “

/PAIR” button on the remote control or on the unit.

Tips:

• Enter "0000" for the password if necessary.

• If no other Bluetooth device pairs with this player within two minutes, the player will recover its

previous connection.

• The player will also be disconnected when your device is moved beyond the operational range.

• If you want to reconnect your device to this player, place it within the operational range.

• If the device is moved beyond the operational range, when it is brought back, please check if the

device is still connected to the player.

• If the connection is lost, follow the instructions above to pair your device to the player again.

NFC (Near Field Communication) Operation

Pair your NFC-enabled mobile device directly with this unit by just a single tap.

1. Activate NFC on your mobile device.

2. Tap the mobile device on the NFC sensing area

of the unit. The device vibrates or a message

pops up. Your unit will switch to Bluetooth mode

automatically.

3. Operate your mobile device directly for playback

features.

4. To disconnect, tap the mobile device on the NFC

sensing area of the unit to disconnect or disable

NFC from your mobile device.

NOTE:

• The NFC function only works with mobile devices that support NFC technology.

• You may need to remove your mobile device case to connect using NFC.

Listen to Music from Bluetooth Device

- If the connected Bluetooth device supports Advanced Audio Distribution Profile (A2DP), you can

listen to the music stored on the device through the player.

- If the device also supports Audio Video Remote Control Profile (AVRCP), you can use the player's

remote control to play music stored on the device.

1. Pair your device with the player.

2. Play music via your device (if it supports A2DP).

3. Use supplied remote control to control play (if it supports AVRCP).

- To pause/resume play, press the

/PAIR button on the remote control or on the unit.

- To skip to a track, press the

buttons on the remote control.

NFC sensing area