Installation Instructions

DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a learning frequency function
which has code combinations to prevent potential interference from other remote units.
Step: 1 Open the remote battery cover and install DC1.5V*2pcs battery.
Step: 2 Within 30 seconds of turning the Receivers DC power ON. press the transmitter “ON/OFF
and Timer” button together about 3 seconds, once the receiver has detected the frequency, the
receiver will make sound, Bi Bi, twice. This will indicate the receiver has learned the frequency that
was previously selected on the transmitter.
Note: After the DC power is on, do not press any other button on the transmitter before setting
learning. Doing so will cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling fan and light. If the fan
is not responding to the transmitter, please turn the power off to the receiver. And repeat step 1
and 2.
Remove the battery if not used for long periods of time to prevent damage to the hand held remote.
FUNCTIONS OF TRANSMITTER
1. ：To turn the fan on or turn the fan off . The beginning of fan will be on lowest speed (speed 1), when
turning the fan on.
2. ○
1
Press this button to increasing fan speed and LED indicator would be on the position“1”
3. ○
2
Press this button to decreasing fan speed and LED indicator would be on the position“2”
4. ○
3
Press this button to decreasing fan speed and LED indicator would be on the position“3”
5. ○
4
Press this button to decreasing fan speed and LED indicator would be on the position“4”
6. ○
5
Press this button to decreasing fan speed and LED indicator would be on the position“5”
7. ○
6
Press this button to decreasing fan speed and LED indicator would be on the position“6”
8. : “Timer”, press the button for set fan timer change. The change model is
1hrs->2hrs->4hrs ->8hrs -> 1hrs ->2hrs->4hrs ->8hrs ->….Press this button one time to change
the next timer hours and LED indicator would be on what you set.
9. SW1 : Switch to the“S”will be foreward running , if turn to the“W”,the fan will be reversed.
10. When pressing remote button, the first LED indicator would be on. If you press remote button
and LED indicator would not be on, you should change new DC1.5V*2pcs battery.
11. When pressing remote button, the receiver would make sound one time for indicating of getting signal from
remote well.