User's Manual

 Getting use
1.
Pairing and connecting with Bluetooth cell phone
Before use, you should pair BTC019 with your cell phone. Please make sure
your cell phone is Bluetooth-enabled. Specific pairing steps may vary with
different models of cell phones. Please refer to your cell phone’s user’s
manual for further information.
The general pairing steps are as follows:
a) Keep BTC019 and your Bluetooth cell phone within 1 meter when
pairing;
b) Long press BTC019
ab
out 5 seconds till red and blue light flash
alternately;
c) Activate your cell phone’s Bluetooth function and search for Bluetooth
devices. After the search is completed, select “BTC019” from the
Bluetooth device list;
d) According to the indication, enter password or PIN No:”0000”, and
press ”Yes” or “confirm”;
e) After successful pairing select “BTC019” from the Bluetooth device list
and press “connect”. After successful connecting, red and blue LED will
on.
Remarks:
 Pairing mode will last 2 minutes. If no devices can be connected over 2
minutes, BTC019 will back to standby mode. If you want to repair,
please turn off BTC019 first and then enter pairing mode again.
 After successful pairing, BTC019 and the Bluetooth cell phone will
remember each other, BTC019 will not need to re-pair with the Bluetooth
cell phone next time unless the pairing information is deleted because of
a new pairing.
 Every time BTC019 is turned on, it will connect to last connected devices
automatically.
 Under the status of standby mode, and non-connected with devices, short
press
once, BTC019 will connect with last connected device.
2. Adjusting FM frequency
1) Long press volume up “+” or volume down “—” button once, BTC019
enter frequency adjustable mode and the display will flash. Please short
press volume up or down button to choose previous or next frequency until
the frequency of BTC019 is same as car radio.
4