User Manual

4. Pairing with Bluetooth devices
1) How to enter pairing mode
Function Operation LED
indicator
Indication
tone
Entering
pairing
mode
Ensure the receiver is turned
off, otherwise turn it off first
and then press and hold MFB
button for 6～7 seconds until
red and blue LED flashes
alternately
red and
blue LED
flashes
alternately
Two “DU”
tones
Remark: The pairing mode will last 2 minutes, the receiver will switch to
standby mode automatically if no devices can be connected over 2 minutes.
2) Pairing with Bluetooth mobile phone
Ensure your mobile phone supports A2DP profile. The pairing procedures
will vary depending on different models of mobile phones. Please refer to
your mobile phone user’s manual for further information. The general
pairing procedures are as follows:
1) Place the receiver and Bluetooth mobile phone where they are easily
viewable by no more than 1 meter;
2) Make the receiver enter pairing mode (please refer to “How to enter
pairing mode);
3) Activate your mobile phone’s Bluetooth function and set your mobile
phone to search for Bluetooth devices within range, and select “BTR016”
from the list of devices shown;
4) According to the indication, enter password or PIN No: “0000”;
5) If prompted by your mobile phone to connect, select “Yes” (This will
vary among mobile phone models);
6) After successful connecting, blue LED of receiver flashes twice
quickly every 4 seconds
Remarks:
 If no devices can be connected within 5 minutes, the receiver will turn
off automatically in order to save power.
 After successful pairing, the receiver and the mobile phone will
remember each other, they will no need to re-pair next time unless the
paired informations is deleted.
3