User Manual

Oplink Communications
2 / 3
II. Installation & Workflow
DGL1130 has an USB port, it is plug and play and no installation or configuration
work needed. Please plug the USB port to the computer or other recognizable
devices and it will start to work.
1) When the sensor, which should be matching its system, is triggered, the DGL1130
will receive a 433MHz hex string signal.
2) DGL1130 will transmit the signal to the host device (like a matching Router or AP).
The signal will be processed by a software client and transferred to alert
information to end user
3) And at the same time, DGL1130 will send out a 433MHz hex string control signal
to the Siren. The siren will receive the control signal and start to work.
4) End user could stop the siren through software client.
III. User Instruction
Please plug the USB port to the computer or other recognizable devices and
power on.
Cautions：
1) LED Indicator
LED light will be permanently on in blue once it is powered up.
LED light will glint once per frame when transmitting wireless signal succeeds.
No special LED indication for receiving wireless signals.
2) Signal Emission
This product does not transmit signal periodically, and, will transmit control
signal to the alarm system only when sensors are triggered.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.