User's Manual

ManualsBrandsZHUHAI KYMODEL HOBBY ManualsElectronicsRemote control

Transmitter

Calibrationfunction

Remotecontrolhasbeensetupforthethrottle,thesteeringneutralpointandthe

maximumstrokecalibration.

Incorrectcalibrationofthethrottlewillresultinthefailureofthemotortooutputthe

fullthrottlesegmentorthenon-linearityofthebackthrottlesegment.Incorrectsteering

calibrationwillresultinthefailureoffullAngleoutputofthesteeringgearor

non-linearityintherearsectionofsteering.Thethrottleandsteeringshouldbe

calibratedonce.Calibrationmethodisasfollows:

Step1

：

Thedirectionisintherightturnposition,thethrottleisinthebrakeposition

Step2：Transmitterstart-upoperationnormally.FiveLEDlightsflashslowly,which

indicateitenterscalibrationmode.

Step3：Pushandpullthethrottlerockertothemaximumpositionofforwardand

brake,calibratethethrottlepotentiometer;

Turnthesteeringwheelleftandrighttothemaximumpositionandcalibrate

thesteeringpotentiometer.

Step4：Releasethethrottlerockerandsteeringwheelbackintothecenter,click

AUX3buttontocalibratethethrottleandsteeringneutralpoints.

Step5：FiveLEDlightsstopflashing,andtransmitterstart-upoperationnormally.

User manual

KYLT-14

Summary of content (4 pages)

PAGE 1
User manual KYLT-14 Transmitter Calibrationfunction Remote control has been setup for the throttle, the steering neutral point and the maximum stroke calibration. Incorrect calibration of the throttle will result in the failure of the motor to output the full throttle segment or the non-linearity of the back throttle segment.Incorrect steering calibration will result in the failure of full Angle output of the steering gear or non-linearity in the rear section of steering.
PAGE 2
User manual STDRSetting Click or long press ST DR“+”or“-”，it can set steering size. All five lights are o，it means that ST DR is set as maximum；if only one light is on,it means that ST DR is set as minimum. STneutralpointfine-tuningfunction Click or long press ST TRIM“+”and “-”,the neutral point of steering can be fine-tuned.
PAGE 3
User manual Receiver Interfacespecification Warning：Make sure that the positive and negative poles of the battery interface,SI-2REE, are installed correctly,if wrong, it will be burnout.。 LEDlightstatusofreceiver determination When the receiver enters the bind, LED light will flash(75ms) . When the receiver is at at low voltage, LED lights will flash at 500ms intervals. When the receiver and transmitter connected normally, LED light keep be on.
PAGE 4
User manual Step1：When receiver turn on,click the button and the LED light will flash and enter BIND mode. Step2：When transmitter turn on,one LED light of transmitter keep flash. Step3：LED light of receiver keep be on, the transmitter match with receiver. Step4：The transmitter match with receiver sucessfully. FCC Statement This device complies with Part 15 of the FCC rules.