User's Manual

• Inspect if the power switch of access point (wireless router) is turned on.
• The printer cannot find the SSID of the access point (wireless router) you need to connect, please check the SSID of access point and try to connect again.
• Every time when the setup of access point (wireless router) is changed, you must set up the wireless network of printer again.
3. Connection failure
• Please inspect if the safe mode and password of access point (wireless router) and printer is correct.
• Inspect the wireless receiving around printer. Signal receiving may be affected if the router is away from the printer or there is an obstacle between them.
• Turn the power of access point (wireless router) and printer off and then restart them and set up.
4. The following aspects should be inspected if the printer has problems while they are used in network:
• Inspect if the firewall software blocks communication. If the computer and printer are connected in the same network but they cannot be searched, the communication might be
blocked by firewall software. Please refer to the user guide of firewall software to turn firewall off and then try to search the printer again.
• Inspect if the IP address assignment of printer is correct. You can inspect IP address by printing the network setup information page of printer out.
Note: • Please refer to the user guide or consult the manufacturer for information related to access point (wireless router).