User's Manual

User Manual
-Start a New Journey of Thock and Clack-
FCC Requirement
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Company Name: Zhuhai Qiannuo Tech. Co.,Ltd
Address: Room 906-2, Floor 9, Building 2, No.88 Xiangshan
Road, Tangjia Town, High Tech Zone, Zhuhai, China
Email: [e-mail] | [e-mail]
Official Website: www.keydous.com
Notice
① WiFi will interfere the Bluetooth signal. Make sure the
keyboard far away from the WiFi devices if the Bluetooth gets
delay evidently.
② DO NOT swap the switches with hard force. Or the socket
even the entire PCB may get DAMAGED.
③ DO NOT put the keyboard in the high-temperature,
high-pressure or sun direct places due to the built-in battery.
④ DO NOT charge the keyboard with charging current that
OVER 5V 1A or the PCB will be DAMAGED. It is better to use the
original cable to charge.
FKeydous mechanical
keyboard