User's Manual

USER MANUAL
63
Chapter 7 Remote Access via Web Client
Use the Web Client to remotely access your WIRELESS NVR at any time via a PC. Before you
access the Web Client, you need to ensure that the network settings of the WIRELESS NVR are
configured properly. The most convenient and easiest way is if you have set the WIRELESS NVR
a static IP address (please see “5.5.1 Network”). It means you only need to open the web browser
on your PC and type in the static IP address you have set on the WIRELESS NVR. However, if the
IP address of the WIRELESS NVR is assigned by a DHCP server (see“5.5.1 Network”), then it
means that each time you reboot the WIRELESS NVR, the IP address changes. In this case, ask
if your ISP can provide you a static IP address. If not, then configure the DDNS service. See the
network settings in “5.5.4 DDNS”.
System Environment Requirements
The minimum requirements for hardware and OS required to run Web Client are given as below.
Item
Minimum
Recommended
CPU
Intel i3
Intel i7 or higher
RAM
4G or more
8G or more
Hard Drive
500G or more
1000G or more
Display RAM
2G or more
4G or more
Display Resolution
1280*1024
1920*1080
OS
Windows® Vista, Windows® 7 ,Windows® 8
Mac OS X® 10.9 and above
DirectX
DirectX 11
Direct3D
Acceleration Function
Ethernet Adapter
10/100M Ethernet Adapter
IE
Microsoft Internet Explorer (Ver. 11,10,9,8)
Mozilla Firefox
43.0.4 or above
Google Chrome
V44 or below
Mac Safari
5.1 or above