User's Manual

8
Radio Frequency Magnetic Field Conduction Immunity: Grade 3 (10V/m)
Power Frequency Magnetic Field Immunity: Grade 5 (100A/m)
Pulsed Magnetic Field Immunity: Grade 5 (100A/m)
vii. Warning
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with minimum
distance 20cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.、
changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Antenna Installation:
WARNING:
It is installer’s responsibility to ensure that when using the authorized
antennas in the United States(or where FCC rules apply),only those antennas certified
with product are used.The use of any antenna other than those certified with the product is
expressly forbidden in accordance to FCC rules CFR47 part 15.204.The installer should
configure the output power level of antennas,according to country regulations and per
antenna type. Professional installation is required of equipment with connectors to ensure
compliance with health and safety issues.