User's Manual

Ⅳ. Reverse switch for CH1~CH4 are beside the power switch.
Ⅴ. In the left corner, there is a trainer switch, when the 2 transmitter connected by a
trainer core with the trainer jack at the back of the transmitter, stir the trainer switch
can make the two transmitters have the trainer function.
Ⅵ. As the picture 2 shown, it is the back drawing of the transmitter, at the bottom left
side is charger jack, below is the connect form of R6M-72F receiver, servos, and
battery pack.
Note:
This equipment has been tested and found to comply with the limits for a digital
device, pursuant to part 95 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instruction may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
TV which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.