Operation Manual

fter having ignited the heater, always check whether the combustion

chamber

D is level, by sliding it slightly to the left and the right by its handle E

(Fig. E). This should be a smooth movement. If the combustion chamber is not

level, this will cause smoke and soot to develop.

D BURNING OF THE HEATER

After you have ignited the heater, it will take 10 to 15 minutes before you can check

whether the heater is burning well. Too high a flame may cause smoke and soot,

whereas too low a flame causes smells. The page opposite the folding page shows

the minimum and maximum permissible burning heights of the flame (Fig. O). The

flame can be slightly adjusted with the knurled wick adjustment knob

2 (Fig. L).

Burning that is too low may be caused by:

E insufficient fuel (fill the tank)

E poor fuel quality (contact your dealer)

E insufficient ventilation (put window or door ajar)

E wastage of the wick (contact your dealer or replace the wick,

refer to section L)

This heater is fitted with a safety system that ensures that it switches off if you

lift the exchange tank out of the heater. To switch the heater on again, put the

exchange tank back and follow the steps in

chapter C.

E SWITCHING OFF THE HEATER

Push the OFF-button A. The flame will extinguish after a little while.

F MALFUNCTION, CAUSES AND SOLUTIONS

If any malfunctioning cannot be solved from the directions below, please contact

your dealer.

THE HEATER DOES NOT IGNITE

E The batteries are not positioned correctly in the holder.

Check (Fig. F).

E There is not enough power left in the batteries for the ignition.

Replace (Fig. F).

E You have run out of fuel from the tank or the wick has been replaced.

After having refilled and replaced the removable tank, wait for 30 minutes

before igniting the heater.

E Y

ou are pushing the ignition button

C with too much for

ce.

Push it in less forcefully (Section C).

E The ignition coil K is defective.

Contact your dealer

IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS

E The combustion chamber D has not been positioned correctly.

Use the handle E to put it level, until you can easily slide it slightly to the left

and to the right and the chamber is level.

☞